Instructions / Assembly

SL0213 INSTRUCTIONS (PAGE 3 / 4)
9. SOLAR PANEL OPERATION
NOTE: The LED light is designed to only work at nighme.
Connual ON Mode: Press [Power on/o] buon,
the top indicator light [connual on] will be lit — the
pump will run connuously unl the baery power
runs out. The pump will automacally restart when
the solar panel baery has been suciently charged
with sunlight.
4-Hour Timer Mode: Press [Timer modes] buon unl
the second indicator light [4hrs Timer] is lit — the
pump will run for 4 hours and stop. The pump will not
run again unl the solar panel is manually restarted.
Daily 4-Hour Timer Mode: Press [Timer modes]
buon unl the third indicator light [daily 4hrs Timer]
is lit — the pump will run for 4 hours and shut down
(in standby) for 20 hours; this operaon will repeat
daily at the same me. You can reset the pump's daily
start-up me by switching it on at a new desired me
in this same mode. NOTE: The third indicator light
will blink slowly when the pump has reached the
4-hour runme and be in standby for the following 20
hours. To save baery power, the indicator light will
automacally turn o. You can acvate the indicator
light to check its status with a single push of either
buon; the indicator light will be on for a while and
shut o again.
BATTERY LOW [RED INDICATOR LIGHT BLINKING]:
Baery power is low, and the pump will stop running
soon to protect the baery. The red indicator light will
turn o aer the solar panel receives enough sunlight
for the baery to be recharged.
PLEASE NOTE: This model allows for the baery pack
to be charged with an original electric charger (sold
separately). Only use the original baery charger as
alternaves may damage the baery and will void the
warranty. See contact informaon under WARRANTY
to order the compable charger.
10. PERFORMANCE OF PUMP
The performance of the pump depends on the orientaon
of the solar panel being toward the sun and sunlight
strength; pump performance is not guaranteed when the
solar panel is in the shade or poor weather condions.
Max. Data is obtained during opmal condions (refer
to Technical Data); solar panel performance cannot be
guaranteed if placed in the shade or during poor weather
condions. The performance of the pump also depends
on the baery power level; the pump cannot operate if
baery power is low.
12. BATTERY INFORMATION
The Li-ion backup baery pack, like all rechargeable
baeries, has a limited life span and becomes less
ecient with repeated charge/discharge cycles. As
the capacity of the baery reduces over me, you may
not achieve the full hours of operaon.
If you nd that the baery appears less ecient, try
to "boost charge" it by turning the power o for 1 to 2
sunny days to allow the baery to achieve a maximum
charge. Occasional "boost charges" will help prolong
the baery life. If your baery pack sll does not
perform to expectaons aer a boost charge, replace
it with a new pack.
13. BATTERY REPLACEMENT
IMPORTANT: Only use original backup baery packs;
alternaves may be incompable, which may damage
the system and will void the warranty.
See contact informaon under WARRANTY (page 4)
to order the compable replacement baery pack.
▪ Remove the screws
(part 1) from the control
panel cover (part 2) using a
Phillips-head screwdriver.
▪ Disconnect the baery
pack connector (part 3),
and remove the baery
pack (part 4) from control
panel base (part 5).
▪ Connect the new baery pack connector to the
control panel base and insert the baery.
▪ Replace the panel cover and ghten the screws.
11. MAINTENANCE OF PUMP
This solar pump is designed to last for years if it is
properly cleaned and maintained. If the pump starts
losing power or stops working, clean the pump lter
and impeller with clean water.
j Front Case k Filter l Impeller Cover
m Impeller n Pump
Dispose of the baeries in accordance
with local laws and regulaons.
12/2022SL-0213B/E/W
SL0213 INSTRUCTIONS (PAGE 4 / 4)
14. TROUBLESHOOTING
Check all solar panel, pump, and LED light connecons.
Make sure connecons are secure and the cables are
plugged into the correct ports on the control panel.
Ensure the solar panel is correctly posioned in a full-
sun locaon and is not shaded by trees, shrubs or
buildings; refer to page 2.
Check the control panel and conrm it is set to the
preferred operaon seng; refer to page 3.
If the [Baery Low] light is blinking, the baery pack
power is crically low and requires charging. Switch o
the pump and leave the solar panel in direct sunlight
for at least 6 hours to recharge the baery pack.
Check the water level to make sure the pump is fully
submerged.
Check the fountain tubing for kinks and obstrucons.
Also, check to make sure the tubing is ghtly
connected to the pump.
Check the pump to make sure it is not blocked by or
clogged with debris.
The pump may be "air locked" from water levels
geng too low or addional water being added. Turn
the pump on/o several mes to clear any air that
may be trapped inside the pump.
17. WARRANTY
Thank you for choosing Sunnydaze Decor. We stand
behind our brand and the quality of the items we
sell. Replacement parts or products will be sent at
our discretion within the 1-year warranty period.
Proof of purchase, with the date of purchase as
well as photos of the merchandise defect, must be
provided. Photos are used to determine the cause of
defects and for future quality control. Register your
warranty at https://tiny.cc/SunnydazeWarranty
If you have any questions, comments or concerns,
feel free to contact us by phone at 833-982-1977,
email: [e-mail], or
via our Contact Us page at
https://tiny.cc/SunnydazeContact
IMPORTANT!
Fully charge the baery before storing. Over me,
baery power discharges, so if it is stored at no
charge, there is a chance it won't accept a charge
again. To avoid this problem, disconnect the pump
and leave the solar panel in direct sunlight for 1 or 2
days to ensure the baery has been recharged.
15. TECHNICAL DATA
MAX. PUMP WATER FLOW: 250LPH
MAX. PUMP WATER LIFT: 90 cm
PUMP WORKING VOLTAGE: DC8.4V~DC6.5V
PUMP WORKING POWER: 1.2W~0.6W
PROTECTION GRADE OF PUMP: IP68
SOLAR PANEL: 2.5W-9V-0.277A
SOLAR PANEL SIZE: 190 x 150 x 18 mm
PROTECTION GRADE OF PANEL: IP44
LI-ION BATTERY PACK: 7.4V/1.5Ah
PROTECTION GRADE OF BATTERY BOX: IP44
LED LIGHT WORKING VOLTAGE: DC7.4V
LED LIGHT WORKING POWER: 0.15W
PROTECTION GRADE OF LED LIGHT: IP68
16. CARE INFORMATION
▪ Check the water level frequently to ensure the pump
remains submerged; never allow the pump to run
dry as it will burn out the motor.
▪ Clean the fountain, pump, and solar panel regularly.
Do not use abrasive materials or harsh chemicals,
such as bleach or chlorine, to clean the fountain.
▪ Always shut off the power supply before cleaning and
maintaining the fountain and the pump.
▪ During freezing weather, drain the fountain,
disconnect the pump, cables and solar panel, and
store indoors; allowing ice to form inside the fountain
will damage the fountain and void the warranty.
▪ The opmal temperature for lithium baeries is
10°C to 45°C, do not use the product beyond this
temperature range.
12/2022
Purchase Date: / /
Order/Customer Ref. Number:
SL-0213B/E/W