Instructions / Assembly
TABLETOP TORCH
1. Simply place the torch vessel on a table or a at, level surface.
CAUTION
Do not place torch under covered shelter or umbrella, near pedestrian trac or
combustibles such as, but not limited to, wood structures, fuel, clothing, etc.
8191129 Page 2 / 3 09/2020
ASSEMBLY / INSTALLATION
FILLING AND LIGHTING
1. Unscrew the metal ame guard from the torch vessel.
2. Fill the torch vessel with torch fuel (not included) until the fuel is 1/2 inch below the bottom rim of vessel.
DO NOT OVERFILL. WIPE AWAY ANY SPILLED FUEL BEFORE LIGHTING.
3. Position the wick so 3/4 inch of the wick is exposed on the ame guard.
4. Reattach the ame guard to the torch vessel. DO NOT OVER-TIGHTEN
5. Allow the wick to absorb and become saturated with the torch fuel before lighting the wick.
6. Use a long lighter or a long replace match to light the berglass wick.
3/4'' Proper
Wick Height
IMPORTANT: When the torch is not in use, leave the snuer on the torch to prevent
water contamination. If the fuel becomes contaminated with water, the wick and fuel must be
replaced. Torch fuel must be properly disposed of in accordance with local laws and regulations.
EXTINGUISHING
1. Carefully place the metal snuer over the lit wick until it is completely extinguished. DO
NOT BLOW OUT
CAUTION: Snuer may become hot while ame extinguishes. If ame does not
extinguish, use re-resistant gloves to hold the snuer over the wick until the ame
is completely extinguished.