Instructions / Assembly

Extinguishing
1. Using the metal snuffer provided, carefully place the snuffer completely over the lit
wick until the flame is extinguished (Figure 4). – DO NOT BLOW OUT
**Note: When not in use, leave the snuffer on the torch to prevent water
contamination. If the fuel becomes contaminated with water, the wick
and fuel must be replaced and properly disposed of in accordance with local
laws and regulations.
Refilling
1. Carefully place snuffer over flame guard to extinguish flame.
– DO NOT BLOW OUT
– Allow to cool for 30 minutes before handling and refilling
2. Unscrew the metal flame guard from the glass vessel.
3. Fill the glass vessel to 1/2 inch (13 m) below seam with torch fuel.
– DO NOT OVERFILL
4. Wipe away any spilled fuel before lighting.
5. Reattach the metal flame guard to the fuel canister.
– DO NOT OVERTIGHTEN
Wick Replacement
1. Carefully remove the wick from the flame guard and properly
dispose of the wick in accordance with local laws and regulations.
2. Insert the new torch wick (Figure 5) and position the wick with
3/4 inch of the wick exposed.
3. Trim as needed.
Storage
1. Store fuel in original fuel bottle with cap secured.
2. Dispose of any unwanted fuel in accordance to local laws and regulations.
3. Store torches in an upright position in a dry location.
4. For best results, store product away from the weather conditions when not in use.
Cleaning
1. When not in use, use a damp cloth to remove debris from the glass vessel as needed.
Figure 4
Figure 5