Installation Manual

ManualsBrandsSunpak ManualsOutdoor Living48" Outdoor Infrared Heaters with Two Stage Hardwired, Ceramic Infrared Burner System, Direct Spark Ignition, in Black

FOR YOUR SAFETY:

If you smell gas:

1. Open windows.

2. DO NOT try to light any appliance

3. DO NOT use electrical switches

4. DO NOT use any telephone in your

building

5. Leave the building

6. Immediately call your local gas

supplier after leaving the building.

Follow the gas supplier’s

instructions.

7. If you cannot reach your gas

supplier, call the Fire Department

WARNING

Fire Hazard

Do not store or use gasoline or other

flammable vapors and liquids in the vicinity

of this or any appliance.

Failure to follow these instructions can result

in death, injury or property damage.

WARNING

Fire and Explosion

Improper installation, adjustment, alteration,

service or maintenance can result in death,

injury or property damage. Read the

installation, operation and service manual

thoroughly before installing or servicing this

equipment.

Installation and replacement of gas piping,

gas utilization equipment, or accessories,

and repair and servicing of equipment shall

be performed by a qualified agency familiar

will all precautions required regarding this

type of equipment and that has complied

with all requirements of the authority having

jurisdiction.

Infrared Dynamics

SUNPAK

Gas-Fired, Unvented

High-Intensity

Infrared Heaters

For use Indoor/Outdoor

Not for use in residential dwellings

NOTE: See page 2 for Definition of Outdoors

Installation, Operation

& Maintenance Manual

Model S25

Model S34

Installer

Please take the time to read and understand these

instructions prior to any installation. Installer must be

given a copy of this manual to the owner.

Owner

Keep this manual in a safe place in order to provide

your serviceman with the necessary information.

Infrared Dynamics, Inc.

3830 Prospect Avenue

Yorba Linda, CA 92886

Telephone: (714) 572-4050

Fax: (714) 572-6093

Toll Free: (888) 317-5255

www.sunpak.us

Printed in the U.S.A.

P/N 65134-7/14

Summary of content (16 pages)

PAGE 1
Infrared Dynamics FOR YOUR SAFETY: If you smell gas: 1. Open windows. 2. DO NOT try to light any appliance 3. DO NOT use electrical switches 4. DO NOT use any telephone in your building 5. Leave the building 6. Immediately call your local gas supplier after leaving the building. Follow the gas supplier’s instructions. 7.
PAGE 2
Sunpak® Infrared Heaters Table of Contents 1. 2. 3. 4. 5. 6. Owner’s Manual Design Guide Installation / Service Instructions Replacement Parts Trouble Shooting Guide Warranty WARNING Prop.
PAGE 3
Sunpak® Infrared Heaters Heater Layout and Design Sunpak® heaters were specifically designed to provide heated comfort in an outdoor environment. They have been used on outdoor patios across the United States and Canada for over 20 years. When properly integrated into a patio design, Sunpak® heaters generally increase the comfort level 5 to 10 degrees Fahrenheit outdoors. The heating effectiveness will depend on air temperature, wind velocity and other factors.
PAGE 4
Sunpak® Infrared Heaters CEILING MINIMUM CLEARANCE FROM COMBUSTIBLE MUST BE MAINTAINED (see chart opposite page) SUNPAK will raise the comfort level 5-10º Fahrenheit outdoors. The above coverage table was based on still breeze conditions. Under windy conditions more heat will be required. It is recommended that a windswept patio be designed with wind breaks to stabilize the patio environment. Wind breaks shall NOT interfere with the ventilation of combustion air requirement of the heater(s).
PAGE 6
Sunpak® Infrared Heaters Installation/Service Instruction Receiving Equipment On receipt of equipment it is suggested that a visual inspection be made for external damage to the carton. If the carton is damaged, a note should be made on the Bill of Lading when signing for the equipment. Remove the heater from the carton. If there is damage, report the damage to the carrier immediately. Gas Supply The gas inlet supply pressure and manifold pressure required for each heater are listed below.
PAGE 8
Sunpak® Infrared Heaters Fire Sprinklers Fire Sprinklers must be located at an appropriate distance from each heater to avoid accidental activation of the sprinkler. Ethylene glycol or propylene glycol must never be used in fire sprinkler systems where heaters are present as these substances may become flammable when heated.
PAGE 9
Sunpak® Infrared Heaters Ventilation 1. 2. 3. It is required that areas above the heater be properly vented to allow for necessary combustion air and removal of combustion gases. Heaters shall be provided with natural or mechanical means to supply and exhaust at least 4 cfm per 1,000 BTU per hour of heater input. Exhaust opening for removing the flue products shall be above the level of the heaters. Heater ventilation must comply with state and local codes. Gas Piping 1. 2. 3. 4. 5. 6. 7.
PAGE 10
Sunpak® Infrared Heaters Servicing Instructions Turn off gas and electrical before attempting any service to this appliance. Heater may be serviced by opening the door to control compartment. Rotate round disk on control door 90 degrees to open. Top of heater may be removed for servicing by removing six (6) screws holding top in place. The top should be removed if the gas controls, burner or burner orifice is to be replaced. 1. Removal of Burner a.
PAGE 11
Sunpak® Infrared Heaters 11
PAGE 12
Sunpak® Infrared Heaters 12
PAGE 13
Sunpak® Infrared Heaters 13
PAGE 14
Sunpak® Infrared Heaters 14
PAGE 15
Sunpak® Infrared Heaters Trouble Shooting Guide Problem Possible Causes No Spark to Pilot       Voltage under 24 VAC Bad Fuse (Ram-3 Module Only) Improper spark gap (7/64” or .
PAGE 16
Sunpak® Infrared Heaters LIMITED WARRANTY THIS WARRANTY IS APPLICABLE TO THE ORIGINAL OWNER ONLY in accordance with the warranty terms and conditions specified below. One Year Homeowner Limited Warranty/90 Day Commercial Warranty Infrared Dynamics (warrantor) will furnish the original owner replacement parts for any component part which fails before one year of residential use , or 90 days commercial use, following installation.