Owner’s Manual Air Cleaner with Photo-Catalytic Oxidation Device & Negative Ionizer Model AC-7013 SUNPENTOWN INTERNATIONAL INC.
INTRODUCTION Thank you for purchasing the MAGIC CLEAN Air Cleaner. Please Read and Save The Instructions. FEATURES Photo-Catalytic Oxidation When a Photo-Catalyst titanium dioxide (TiO2) captures Ultraviolet light (UV), activated oxygen is formed from water or oxygen in the air. Similar to the process of photosynthesis in green plants, where chlorophyll captures sunlight and turns water and carbon dioxide into oxygen and glucose.
SETUP Your Air Cleaner was thoroughly inspected and tested at the factory prior to packaging. Visually inspect it upon removal from its packaging. Return the unit if it shows any signs of damage or mishandling. WARNING: To Avoid Fire Or Shock Hazard, This Unit Should ONLY Be Plugged Into A Polarized 120 Volt AC Outlet. IMPORTANT SAFETY INSTRUCTIONS Please read all instructions before using this product. Save these instructions for future reference.
the mesh needs to be changed. THE TiO2 MESH IS NOT WASHABLE. Filter replacement processes are as below: 1. Turn the Air Cleaner OFF and unplug the unit from the power outlet. 2. Using attached open-grill tool pressure in the two notches located on the corner of rear grill, make the front grill separate from rear grill. 3. Remove whole front grill from rear grill. 4. Remove TiO2 Mesh from front grill and discard it. 5. Remove any protective plastic wrapping and packaging from the new TiO2 Mesh. 6.
TECHNICAL SPECIFICATIONS Length Width Height Weight Input voltage 5.5 in. 11 in. 13 in. 3.5 lb. 120 volts AC, 60Hz REPLACEMENT PARTS Part Number Part Name Size AC-13 TiO2 Mesh 230 X 250 X 4 mm CUSTOMER ASSISTANCE LINE If you experience a problem, please see the warranty for information. Please DO NOT attempt to repair this unit yourself. Doing so, will void your warranty and could cause damage to the Virus-free Air Circulator or personal injury to yourself.