Instruction Manual Tower Ceramic Heater Model : SH-1508 It is important that you read these instructions before using your new purchase and we strongly recommend that you keep them in a safe place for future reference. Press main power switch on the bottom of unit after it is plug into an outlet.
Table of Contents SPECIFICATIONS………………………………………………………………………………..1 GENERAL SAFETY INFORMATION…………………………………………………………..1 PARTS NAME….…………………………………………………………………………………2 ASSEMBLY AND USAGE……………………………………………………………………….2 LCD Display…………………………………………………...…………………………………..3 REMOTE CONTROL…………………………………………………...………………………...4 SAFETY FEATURES……………………………………………………………………………..4 MAINTENANCE……………………………………….…………………………………………..
Specifications Model Number SH-1508 Dimension 8.7" x 8.7" x 23.8" Heating Element Ceramic Safety Power Indicator Light, Tip-Over Protection Shut-Off, Current Fuse, Thermostat, Thermal Cutoff Rated Power 1,500W / 12.5A Ion Function Yes Air Filter Yes LCD Display Blue Timer 7.5 hours Color Silver Remote Control 64 0F - 90 0F Approval ETL General Safety Information Read carefully attempting to assemble, install, operate or maintain the product described.
8. Do not pull the power cord to disconnect from power source. Always grasp the plug to remove. 9. Do not insert any objects into the heater as it may cause an electric shock, fire, or damage to the heater. Do not block or tamper with the heater in any manner while it is in operation. To prevent a possible fire, do not block air inlet or outlet in any manner. Do not place on soft surface, like bed, where opening may become blocked. 10. Always unplug heater when not in use. WARNING: 11. 12. 13. 14. 15.
ASSEMBLY AND USAGE The heater may be operated by the manual controls located on the heater (as shown in FIGURE 2) or by your remote control (shown in FIGURE 8). 1. Carefully remove the heater from the plastic bag and the carton. 2. Assemble the two detached half pans and fasten the screws on the bottom of the pan (as shown in FIGURE 1). Place the heater on a stable flat surface. 3. Plug the power cord into a power socket.
7．OSC: Pressing the ‘OSC’ button will allow the heater to oscillate. To stop the oscillation, press the ‘OSC’ button once more. (Auto oscillation is 70 degrees and manual oscillation is 60 degrees). (FIGURE 5) 8． TIMER: The timer function allows you to set the length of operation from 0.5 hour to 7.5 hours. Pressing the ‘TIME’ button will increase the length of operation by 0.5 hour each time. (As shown in FIGURE 6) 9.
MAINTENANCE WARNING: CLEANING: CAUTION: STORAGE: ALWAYAS UNPLUG THE CORD BEFORE MOVING OR SERVICING, DO NOT IMMERSE HEATER IN WATER. IMPORTANT! DO NOT IMMERSE HEATER IN WATER! Take the Air Inlet and the Air Filter off, clean the Air Inlet with the vacuum brush attachment on your Vacuum cleaner, and wash the Air Filter in warm water and dry it. DO NOT DRY AIR FILTER IN DIRECT SUNLIGHT. Clean the body of the Heater with a soft cloth. Do not use gasoline, benzene, thinner, harsh cleaners, etc.
Your Guarantee If this product is found to be faulty as a result of faulty materials or workmanship within one year from date of purchase, it will be repaired free of charge. This guarantee is subject to the following terms: • Sunpentown must be notified of the fault. • Proof of purchase must be presented to Sunpentown’s nominated representative. • The warranty will be void if the product if modified, misused or repaired by an unauthorized person.
