Manualshelf

Data Sheet

ManualsBrandsSUNPOWER TECHNOLOGIES ManualsPSU ComponentsAC/DC PSU module 24 Vdc 1.1 A
12
SUNPOWER TECHNOLOGY CORP.
16F.-1, No.150, Jian 1st Rd., Zhonghe Dist., New Taipei City 235, Taiwan (R.O.C.).
TEL: 886-2-8226-3100 FAX: 886-2-8226-3111
http://www.sunpower.com.tw
E-mail: sunpower@sunpower.com.tw
SPS-025-xx Series
Copy Right Sunpower Technology Corp. 2009, All Rights Reserved. SPS-025-xx Rev 1.8
Specifications subject to change without notice. RS-100109 MAR-24-2020
QR0405-1 Rev,:1.0
Features:
＊ Green mode design, no load < 0.3W
＊ High efficiency and high reliability
＊ Built in EMI filter, low ripple noise
＊ Over voltage protection：Voltage limited mode
＊ Over load ＆ short circuit protection：Hiccup mode
＊ Output voltage ±10% adjustment
＊ 100% full load burn-in test
＊ -20℃~70℃ Operating temperature
＊ UL, cUL, TUV, CB, CE approved
＊ 3 years warranty
Specification:
INPUT
Voltage
88V ~ 264VAC universal full range or 125V ~ 375VDC.
Frequency
47 ----- 63 Hz
Current
<0.65A@100V AC input, full load condition
Inrush Current (TYP.)
30A@115V , 50A@230V AC input, Cold start at 25℃ ambient
Leakage Current
<0.5mA@264V AC input
MODEL No.
SPS-025-3.3
SPS-025-05
SPS-025-7.5
SPS-025-12
SPS-025-15
SPS-025-24
SPS-025-30
SPS-025-48
Voltage
3.3V
5V
7.5V
12V
15V
24V
30V
48V
Min Load
0A
0A
0A
0A
0A
0A
0A
0A
Max Load
6A
5A
3.4A
2.1A
1.7A
1.1A
0.9A
0.57A
Output Tolerance
± 3%
± 2%
± 1%
± 1%
± 1%
± 1%
± 1%
± 1%
Ripple Noise MAX.
70mV
70mV
80mV
120mV
150mV
150mV
200mV
200mV
Efficiency (TYP.)
72%
79%
80%
84%
85%
86%
87%
88%
Output MAX.
20W
25W
25W
25W
25W
27W
27W
27W
Over Voltage
3.8~4.6V
5.8~7.0V
8.6~10.5V
13.8~16.8V
17.3~21.0V
27.6~33.6V
34.5~42.0V
55.2~67.2V
Limiting voltage latch
Over Load ＆ Short Circuit
When power supply over 105%~ 180% max load or short circuit acted, power supply will go into hiccup mode
and recover automatically after the fault is removed.
Rise time
<30mS
Hold up time
>60mS@230V, full load condition
Setup time
<1 Sec@100 ～ 240V AC
Green mode function
Power consumption at no load < 0.3W at 240VAC input
Temperature
Operating: -20 ~ +70℃ ; De-rating: 50 ~ 70℃: 2.5%/℃ ; Storage: -40 ~ +85℃
Humidity
Operating: 20% ~ 90% RH (non condensing) ; Storage: 10% ~ 95% RH (non condensing)
Altitude
6562 ft ( ≒ 2000 m) operating
Withstand voltage
I/P-O/P:3KVAC, I/P-FG:1.8KVAC, O/P-FG:0.5KVAC, 1minute
Isolation resistance
I/P-O/P, I/P-FG, O/P-FG ＞100MΩ/500VDC at 25℃/ 70% RH
Safety standard
UL 62368-1 2
nd
Edition, 2014-12-01, CAN/CSA C22.2 No. 62368-1-14, 2
nd
Edition, 2014-12, TUV EN 62368-1:2014+A11,
IEC 62368-1:2014 approved
EMI
EN 55032 CLASS B, FCC CFR 47 PART 15 CLASS B approved, CNS 13438 CLASS B standard.
EN61000-3-2 CLASS A, EN61000-3-3 approved
EMS
EN 55024：EN 61000-4-2,3,4,5,6,8,11 approved
Cooling
Natural cooling.
M.T.B.F.
450K hours
Terminal pitch
5P / 7.62mm with plastic cover
Packing
N.W.: 0.18 Kg / 1pc; 80pcs/ 1.11 CUFT / 1 CTN
All measurements which not mentioned are based on 230VAC input, output Max at ambient 25℃ / 70%RH
Output tolerance included set up voltage, line regulation and load regulation.
NOTE
Ripple & noise are measured at 100〜254VAC input with 10〜50℃ condition and 20MHz of bandwidth by using a 10〞〜15〞twisted pair-wire terminated
with a 0.1uF & a 47uF parallel capacitor.
The operating temperature shall follow the de-rating curve in spec
The power supply is considered a component of end-equipment. The end-equipment must be re-confirmed whether comply with EMC directives.
25W, Single Output
79 x 50.8 x 28.5 mm
3.11 x 2.0 x 1.12 inch
Green mode function
CB

Summary of content (2 pages)