Installation Guide

ManualsBrandsSunPower ManualsFlexibleSunPower SPR-E-Flex-100 Flexible 100 watt Scratch N Dent Solar Panel

Safety and Installation Instructions

United States and Canada

This document applies to all SunPower modules

listed in Table 1.

Contents of this manual are subject to change without notice.

For the latest US & Canada manual please refer to

www.sunpower.com/PVInstallGuideFlexModules

SunPower Corporation

www.sunpower.com

Document 524958 REV A

Summary of content (4 pages)

PAGE 1
Safety and Installation Instructions United States and Canada This document applies to all SunPower modules listed in Table 1. Contents of this manual are subject to change without notice. For the latest US & Canada manual please refer to www.sunpower.com/PVInstallGuideFlexModules SunPower Corporation www.sunpower.
PAGE 2
Safety and Installation Instructions (United States and Canada) 1.0 Introduction This manual provides safety and installation instructions for SunPower flexible photovoltaic (PV) modules IMPORTANT! Please read this manual in its entirety before installing, wiring, or using this product in any way. Failure to comply with these instructions will invalidate the SunPower Limited Warranty for PV Modules. 1.
PAGE 3
Table 1: Electrical Characteristics1 Typical Electrical Data at STC: 25C, 1000 W/m2 and AM 1.5 Model SPR-E-Flex-110 SPR-E-Flex-100 Nominal Power (Pnom) 110 W 100 W Power Tolerance +/–3% +/–3% Rated Voltage (Vmpp) 18.5 V 17.5 V Rated Current (Impp) 6.0 A 5.8 A Open circuit voltage (Voc) 21.7 V 21 V Short curcuit current (Isc) 6.3 A 6.2 A Power Temp Coeffiecient –0.35%/° C Voltage Temp Coefficient –58.9 mV/° C Current Temp Coefficient 2.6 mA/° C Max.
PAGE 4
SunPower recommends using the same brand connector in a PV system as is supplied with the module. Currently approved compatible connectors found on SunPower modules are: Tyco Solarlok PV4 and PV4S, Yukita (YS-254/YS-255) and Multicontact MC4 (PVKBT4/6II, PVKST4/6II). 5.0 Module Mounting The SunPower Limited Warranty for PV Modules is contingent upon modules being mounted in accordance with the requirements described in this section. 5.