User's Manual

ML0304 User Manual
HOW TO USE THE LASER PRESENTER
1. Insert the receiver into the USB port of PC.
2. Your PC operation system will start to install the device
automatically .And you can see the information as below display in your
computer.
3. In Win98/Me operation system you need to follow the instructions on
your screen .During the install process, the O/S may ask you to put
Win98 CD into the CD-ROM.
4. After the installation process is done,the presenter will start
working .
Better than other competition:
1. NO direction and NO level speed precise control.
2. RF (315 or 433 or 900MHZ), Any angle ,reachable distance up to 7 Meters.
3. 256 ID sets and RF-technique to Anti-interference .
4. No matter what PC Off or Battery Out ,The ID will not be loss.
5. Add Page-Up Page-Down Key .
Notice : For trouble shooting
If the presenter is not working :
1. Maybe the battery power is too low , please check your battery .
2. Maybe ID code was not matched ,please link ID.
(1).push the button on receiver side then press left button + right
button within 10 SEC after the receiver ID button was pressed on the
transmitter side.
Laser Pointer
(1).VR-mouse
(2).mouse middle key
Mouse right key
Page up
Mouse left key
Page down
Laser key

Summary of content (3 pages)