User manual

Rutland 914i Windcharger Installation & Operation
Doc No:SM-137 Iss. C 13.02.13 6 Marlec Eng Co Ltd
x The fuse supplied must be fitted to protect the system.
x The Rutland 914i Windcharger is suitable for sailing boats and some land
based applications. When storm winds are forecast the turbine can be re-
strained to minimise wear and tear particularly when installed on land based
applications where Furlmatic model windchargers are normally recommended.
Note that where the manufacturer recommends a furling type windcharger
should have been used the warranty is invalidated in cases of storm damage.
x If in doubt, refer to your dealer, a competent electrical engineer or the
manufacturer.
Check You Have Received - See Rutland 914i Exploded View
x 24 x No.10x25mm special self-tapping screws for aerofoil blades
x 1 x No.4 x 13mm self tapping screw for tail bracket covers
x 2 x M6 x 16mm hex. Head screws for tail fin
x 2 x M6 nylock nuts for tail fin
x 1 x fuse and fuse holder
x 1 x main generator assembly
x 6 x aerofoil blades
x 1 x tail fin
x 2 x tail bracket covers
x 1 x nose cone + 3 x nylon fixing screws
x 1 x 6mm Allen key
x 1 x 2-way terminal block
x 2 x M10 buttoncap screws
x 2 x shakeproof washers
In the event of loss or damage, consult your dealer or the manufacturer.