Owner Manual

Sunshine GardenHouseSunshine GardenHouse
Sunshine GardenHouseSunshine GardenHouse
Sunshine GardenHouse
PO Box 2068, Longview, WA 98632
Sunshine GardenHouseSunshine GardenHouse
Sunshine GardenHouseSunshine GardenHouse
Sunshine GardenHouse
PO Box 2068, Longview, WA 98632
2
From Box #4 & 6: Attach side base parts using 1-1/4” screws. Match parts “A”
together and parts “B” together.
From Box #4 & 5: Attach side wall top plate parts using 1-1/4” screws. Match
parts “A” and parts “B”.
Pre-Assembly - 12-foot Lengths
Roof Truss - Box #5
Lay out two rafters and a truss as shown above (A). Attach one rafter to the
truss through the connector using two 1-1/4” screw as shown in (B).
Then use a 2-1/2” screw through the pre-drilled hole in the rafter. Turn the
assembly over and repeat on the other side.
Repeat this procedure to make a total of five roof trusses.
Figure 1 Figure 2
Door & Vent Wind Stops - Box #3
Attach the stops around the door and base vents as shown.
Door Hardware - Box #4
Attach the door pull and barrel bolt.
13
A
B
A
B