Owner's Guide

-6-
WALL MOUNT INSTALLATION
IMPORTANT: Before installing this heater, make sure that a wall stud is located in the center of the unit. This wall stud will give better
support to the unit. See the following instructions to place the "C" angle to the wall stud:
1. Select the elbow position as indicated in Figure 2-1.
2. Drill two (2) 5/16" holes according to the dimensions shown on the upper corner of Figure 2-1.
3. Drill another 5/16" hole on the wall stud for the "U" hook as shown in Figure 2-2.
4. Screw in the three (3) plastic expansion anchors furnished with the unit, as shown in Figure 2-1.
5. Screw in the furnished screws through the anchors as shown in Figure 2-1.
6. Connect the gas line.
Right Side
Dimension A
model SC18T = (13 6/32”) 334 mm
model
S
C30
T
=
(
20 45
/
64") 526 mm