Installation and Operation Manual
Form #43219020 
Sept 2012 
16)  OPTIONAL PARABOLIC REFLECTOR EXTENSION ASSEMBLY 
The heater is completely factory assembled and requires no field assembly. If the optional parabolic reflector 
extension is utilized, locate and identify the end panels 
and  side  panels  as  shown  in  the  following  diagram.  
Attach the side panels as shown. Attach the end panels 
so  that  the  end  flanges  of  the  end  panels  overlap  the 
side  panels.    Attach  the  side  panels  and  end  panels 
together with the screws provided in the kit.  Attach the 
remaining  screws  as  shown  in  Detail  A.    This  is  to 
ensure  that  the  Parabolic  Reflector  Extension  is 
securely  attached  to  the  reflector.    The  clearances  to 
combustibles  (shown  on  the  clearance  label  that  is 
secured to the reflector on the control end of the heater 
and in Section 4  of these  instructions) must be closely 
observed.    Please  order  the  Parabolic  Reflector 
Extension Kit using the Part Numbers below: 
Model No. 
Parabolic Reflector 
Extension Kit Number 
SG3, SG4 
#43822010 
SG6, SG8 
#43822020 
SG10, SG12 
#43822030 
SG13, SG14, SG15 
#43822040 
17)  OPTIONAL PROTECTIVE REVERB SCREEN 
The optional protective Reverb Screen acts as a safety net 
in  the  unlikely  event  that  the  ceramic  tile  assembly  is 
broken  by  an  outside  force.    In  addition,  it  increases  the 
overall emissivity of the radiating surface with a blackbody 
radiation effect.  It is recommended in high-traffic areas as 
well as where improved radiant output is desired.   Please 
order  the  Protective  Reverb  Screen  using  the  Part 
Numbers listed to the right: 
18)  REPLACING PARTS 
At all times when parts are being replaced, ensure that both the gas and electrical supplies are disconnected. 
Various  parts  are  available  from  the  factory  for  replacement  by  a  licensed  service  person.    Refer  to  the 
exploded parts guide in Section 20 for all replacement parts. 
19)  INSTALLATION DATA 
Date of 
Installation: 
Number of 
Heaters in System: 
Heater Serial Number: 
Heater Model: 
 SG 
N =Natural Gas 
L =Propane Gas
18 
Model No. 
Reverb Screen 
Kit Number 
SG3, SG4 
#43876010 
SG6, SG8 
#43876020 
SG10, SG12 
#43876030 
SG13, SG14, SG15 
#43876040 










