Installation and Operation Manual
Form #43219020 
Jan 2014 
1)  SAFETY 
This heater is a self-contained infrared radiant ceramic heater. Safety information required during installation 
and operation of this heater is provided in this manual and the labels on the product. The installation, service 
and maintenance of this heater must be performed by a contractor qualified in the installation and service of 
gas fired heating equipment. 
All personnel  in contact with the  heater  must read and understand  all safety  information,  instructions  and 
labels  before  operation.  The  following  symbols  will  be  used  in  this  manual  to  indicate  important  safety 
information. 
Warning instructions must be followed to prevent or avoid hazards which 
may cause serious injury, property damage or death. 
Caution  instructions  must  be  followed  to  prevent  incorrect  operation  or 
installation  of  the  heater  which  may  cause  minor  injury  or  property 
damage. 
2)  INSTALLER RESPONSIBILITY 
The installer is responsible for the following: 
  The  heater  installation,  electrical  and  gas  supplies  must  be  installed  in  accordance  with  these 
installation instructions and any applicable codes and regulations. 
  Every heater shall be located with respect to building construction and other equipment so as to permit 
access to the heater. 
  Each installer must follow the clearances to combustible materials for the heaters. 
  Install  the  heater  so  that  the  supports  and  hangers  are  correctly  spaced  in  accordance  with  these 
instructions. The heater must be supported by materials having a working load limit of at least 87lbs. 
  Supply the owner with a copy of these Installation and Operation Instructions. 
  Gravity or mechanical means shall be provided to supply and exhaust at least 4 CFM per 1,000 Btu/hr 
input of installed heaters. 
  Never use the heater as a support for a ladder or other access equipment. Do not hang anything from the 
heater. 
  Supply all installation materials necessary that are not included with the heater. 
  Check the nameplate to make sure that the burner is correct for the gas type in the building. 
3)  GENERAL INFORMATION 
This heater is a self-contained infrared radiant ceramic heater for use in locations where flammable gases or 
vapors are  not generally present (as defined by  OSHA  acceptable  limits) and  is  intended for the  heating of 
nonresidential spaces. 
”For indoor installation only. Not for 
use in residential dwellings.” 
«Installation à l’intérieur seulement. Ne 
pas installer dans un logement.» 
2 










