Instruction manual
UK-3
3. Storage
* Store the disc in its case.
* Do not expose discs to direct sunlight or high temperatures, high
humidity or dusty places.
4. Cleaning a disc
* Should the disc become soiled, wipe off dust, dirt and fingerprints
with a soft cloth.
* The disc should be cleaned from the center to the edge.
* Never use benzene, thinners, record cleaner fluid or anti static spray.
* Be sure to close the CD door so the lens is not contaminated by dust.
* Do not touch the lens.
OPERATING THE UNIT
POWER/STANDBY
iPod
CLOCK SETTING
TIMER SETTING
Note: If the display shows "ERROR" while you set the “TIMER ON” it means both “TIMER ON” and “TIMER OFF” is the
same. In
this case, please go to “TIMER OFF” to set the off time first.
When you first plug the unit into the AC outlet, then press the power switch on the rear of the unit, the unit will be in
standby mode, the black light of standby is red. You can now press the STANDBY/ON button on the unit or press the
ST
ANDBY on remote control to switch the unit ON. The black light of the standby and multi function touch plate will
light on blue. Pull the AC plug out of the wall socket if you want to switch of
f completely.
1. Press the STANDBY/ON button on the unit or or press the STANDBY on remote control to switch the unit on.
2. Select the sound source (CD, USB, SD CARD, iPod, AUX or TUNER) by touch the FUNCTION touch plate or
press the FUNCTION on remote control. The corresponding display will light up.
3. Adjust the volume with the VOLUME (UP or DOWN) touch plate on the unit or the remote control.
4. Press the ST
ANDBY/ON button on the unit or press the ST
ANDBY button on the remote control again to turn off the
unit.
During in the STANDBY mode.
1. Press and hold the iPod/MEM/C-ADJ. button until the time displays will change to 24-hour(or 12-hour) digit and flash.
2. Touc
h the SKIP/TUNE SEARCH(UP or DOWN) touch plate on the unit or press the SKIP/TUNE SEARCH(UP or
DOWN) button on the remote control to adjust 12-hour or 24-hour digit.
3. Press the iPod/MEM/C-ADJ. button again, the HOUR digit will flash on the display
, touch the SKIP/TUNE
SEARCH(UP or DOWN) touch plate to adjust HOUR digit.
4. Press the iPod/MEM/C-ADJ. button once more, the MINUTE digit will flash on the display
, touch the SKIP/TUNE
SEARCH(UP or DOWN) touch plate to adjust MINUTE digit.
5. Press the iPod/MEM/C-ADJ. button again to confirm the time.
6. Each enable state as shown above will be cleared if the key is not pushed in10 seconds.
1. After adjusting the clock, press the TIMER button for a few seconds, " ON" and "00:00" appears on the display
and the HOUR digit flashes.(F1)
2. To
uch the SKIP/TUNE SEARCH (UP or DOWN) touch plate or press the SKIP/TUNE SEARCH
(UP or DOWN) button on the remote control to adjust it.
3. Press the TIMER button again, the MINUTE digit will start flashing, adjust it by touching the SKIP/TUNE SEARCH
(UP or DOWN) touch plate on the unit or press the SKIP/TUNE SEARCH(UP or DOWN) button on the remote control.
4. Press the TIMER button once more to confirm and order TIMER ON time.
5. After adjusting "TIMER ON", “ OFF" appears on the display and the HOUR digit flashes.(F2)
6. Repeat the above steps 2 to 3, and then press the TIMER button once more to confirm and order TIMER OFF time.
7. Now the "TUNER" appears on the display with flashing, and then select the alarm mode of the “TUNER, CD, USB,
SD CARD " by touching the SKIP/TUNE SEARCH (UP or DOWN) touch plate.
8. Press the TIMER button again, the timer "VOL" indicator appears on the display and flashes, adjust the timer
volume high or low by touching the SKIP/TUNE SEARCH (UP or DOWN) touch plate or press the SKIP/TUNE
SEARCH (UP or DOWN) button on the remote control.
9. Each enable state as shown above will be cleared if the button is not pushed in 10 seconds.
10.After adjusting "TIMER ON" and "TIMER OFF" ,press the TIMER button, " " appears on the display
.
11.The main unit will be switched on automatically at "TIMER ON" order and start playing, the main unit will be
switched of
f automatically at "TIMER OFF" order.
Note:
1. If there is no signal under the CD/USB DEVICES/ SD & MMC CARD/ mode, the main unit will be switched of
f
within 15 minutes automatically
.
2. During in the iPod mode, there is not insert the iPod Player on the iPod docking bracket. The main unit will also turn
of
f within15 minute automatically.
3. During in standby mode, press any button/key can make the display light for 10 seconds.
4. Please turn the main switch off to save energy, when you do not use the unit.
FUNCTION SELECT
The function is that when it touches the FUNCTION touch plate on the unit or press the FUNCTION button on the
remote control to change the mode of each function. Display changes as below:
F1
F2
AU X
CD
TUNER
USB
IPODSD CARD
RADIO OPERATION
1. the FUNCTION on the main unit to TUNER mode
that to select the FM operation.
Touch touch plate or press the FUNCTION button on remote control
2. Touch the SKIP/TUNE SEARCH(UP or DOWN) touch plate on the unit or press the SKIP/TUNE SEARCH(UP or
DOWN) button on the remote control to tune the desired wave band range of frequency
.
CORRECT INCORRECT
FROM THE CENTRE
TO THE EDGE