Use and Care

The two top illustrations demonstrate how the slide-in type unit is designed to fit into

open-

front enclosures, and supported at the

Countertop.

Do not install this unit under unprotected flammable surfaces. Do not install or

use

this appliance inside a building, garage, or any other covered area. It must not

used in or on recreational vehicles or

boats.

INSTALLER NOTE: This unit should be installed so that it can be removed at a later

date

if factory service is required. Any protrusion into the side burner enclosure may

prevent

the unit from sliding into

place.

ENSURING PROPER COMBUSTION AIR AND COOLING AIR

FLOW

You must maintain proper air flow for your side burner to perform as it was designed.

airflow is blocked, overheating and poor combustion will result. Make sure not to block

the

1" front air inlet along the bottom of the face or more than 75% of the support grid

surface

with pans or

griddles.