Installation Guide

Page 2
APPLIANCE BASE CABINETS – TRIM-KIT OPTIONS
First is to install any “Trim-Kits” you may have
for either large or smaller appliance cabinets in
your island configuration. At this point your
appliance cabinet should appear as shown in
the picture to the right with front, back kick
plate panels installed and the side panel if the
cabinet is on either end of your island
configuration.
Depending on the specific Appliance you have, your cabinet came with a specific Trim -Kit that will fit
each appliance cabinet in your cabinet island configuration. Be sure to measure the inside width of
trim kit, and match up with your own appliance. Use own discretion when with Trim-Kits, as your
specific product cut-out dimensions have not been directly confirmed by any Sunstone Metal
Products LLC. Representative or employee.
Your Trim-Kit will come with either two
smaller separate pieces also with
smaller counter rail pieces included, or
as a single larger piece with center
bottom filler rail connecting the two
sides, and separate top counter rails
pieces separate.
Each Appliance Cabinet is offered with
Five to Six Trim-Kits, each for making
its own cut-out size to accommodate
many more appliance brands available
in the market. If your trim-kit does not
fit with your appliance, please contact
your Sunstone dealer or our technical
support line at 888-934-9449
ATTENTION: Be sure to install all Trim-Kits and End Panels before any
counters are installed.