User's Manual

ST-100M Module
28
4.4.2 Format
Command Possible response(s)
+CRLP=[<iws>[,<mws>[
,<T1>[,<N2>[,<ver>[,<
T4>]]]]]]
+CRLP?
+CRLP: <iws>,<mws>,<T1>,<N2>[,<ver1>[,<T4>]]
[<CR><LF>+CRLP:
<iws>,<mws>,<T1>,<N2>[,<ver2>[,<T4>]]
[...]]
+CRLP=?
+CRLP: (list of supported <iws>s),(list of supported <mws>s),
(list of supported <T1>s),(list of supported <N2>s)[,<ver1>
[,(list of supported <T4>s)]]
[<CR><LF>+CRLP: (list of supported <iws>s),(list of
supported
<mws>s),(list of supported <T1>s),(list of supported <N2>s)
[,<ver1>[,(list of supported <T4>s)]]
[...]]
4.4.3 Field
<ver>, <verx>: RLP version number in integer format; only support version 0.
<iws>, <mws>, <T1>, <N2>, <T4>: IWF to MS window size, MS to IWF window size, acknowledgement timer
T1, retransmission attempts N2, re-sequencing period T4 in integer format. T1 and T4 are in units of 10
ms.
<ver> and <T4> in set command are ignored.
4.5 AT+CR – Service reporting control (Sec 6.9)
4.5.1 Description
Service reporting control.
Set command controls whether or not intermediate result code +CR: <serv> is returned from the TA to the
TE. If enabled, the intermediate result code is transmitted at the point during connect negotiation at which the
TA has determined which speed and quality of service will be used, before any error control or data
compression reports are transmitted, and before the intermediate result code CONNECT is transmitted.
4.5.2 Format
Command Possible response(s)
+CR=[<mode>]
+CR? +CR: <mode>
+CR=? +CR: (list of supported <mode>s)