User's Manual

ST-100M Module
41
7.7.3 Field
<mode>:
0 message types specified in <mids> and <dcss> are accepted
<mids>: We support 10 message identifiers at most.
string type: all different possible combinations of CBM message identifiers (refer <mid>)
(default is empty string);
e.g. "0,1,5,320-478,922"
7.8 AT+CSAS – Save Settings (Sec 3.3.5)
7.8.1 Description
Execution command saves active message service settings to a non-volatile memory. Settings specified in
commands Service Centre Address +CSCA, Set Message Parameters +CSMP and Select Cell Broadcast
Message Types +CSCB (if implemented) are saved. Certain settings may not be supported by the storage
(e.g. (U)SIM SMS parameters) and therefore can not be saved.
7.8.2 Format
Command Possible response(s)
+CSAS[=<profile>] +CMS ERROR: <err>
+CSAS=? +CSAS: (list of supported <profile>s)
7.8.3 Field
<profile>:
0...255 manufacturer specific profile number where settings are to be stored
7.9 AT+CRES – Restore Settings (Sec 3.3.6)
7.9.1 Description
Execution command restores message service settings from non-volatile memory to active memory. A TA
can contain several profiles of settings. Settings specified in commands Service Centre Address +CSCA, Set
Message Parameters +CSMP and Select Cell Broadcast Message Types +CSCB (if implemented) are restored.
Certain settings may not be supported by the storage (e.g. (U)SIM SMS parameters) and therefore can not
be restored.
7.9.2 Format
Command Possible response(s)
+CRES[=<profile>] +CMS ERROR: <err>
+CRES=? +CRES: (list of supported <profile>s)