User's Manual

ST600 User Manual

GROUP_SEND ‘0’ or ‘1’ Group Send for stored data

0 : Disable

1 : Enable. One packet can include up to 5 reports.

Group send is explained below.

MP_CHK ‘0’ or ‘1’ Main Power Disconnection Check

Disable (0) / Enable (1)

ANT_CHK ‘0’ or ‘1’ GPS Antenna Connection Error Check

Disable (0) / Enable (1)

BAT_CHK ‘0’ or ‘1’ Backup Battery Error Check

Disable (0) / Enable (1)

M_SENSOR ‘0’ ~’4’ Motion Sensor

Motion Collision Shock

0 Disable Disable Disable

1 Enable Disable Disable

2 Disable Disable Enable

3 Enable Disable Enable

4 Disable Enable Disable

5 Enable Enable Disable

6 Disable Enable Enable

7 Enable Enable Enable

CALL ‘0’ or ‘1’ Support Call with headset

Disable (0) / Enable (1)

GEO_FENCE ‘0’ or ‘1’ Support Geo-fence

Disable (0) / Enable (1)

DAT_LOG ‘0’ or ‘1’ Log out with RS232

0 = No Use

1 = Enable getting saved log data by RS232

[command] ST600SVC;850000;02;1;120;0;0;0;0;1;1;1;0;0;0;0;0;0;0;0;0

[response] ST600SVC;Res;850000;010;1;120;0;0;0;0;1;1;1;0;0;0;0;0;0;0;0;0

<notes>

** Function of M_SEMSOR can be used with the model that has motion sensor.

If shock or collision detection is enabled, device will report to server when gets any shock or collision.

** If this parameter has been customized, This table should be disregarded and you should follow

customized

operation document.