Install Instructions

IOM-WR-TapeMat 1526 28 of 32

Power Lead

From Mat 2

Power Lead

From Mat 1

Thermostat

or Relay

Thermostat / Relay Connections

Power

Supply

(120 VAC or

240 VAC)

Load 1

Line 1

Line 2

Black

White

Load 2

Standard NM Cable

(12 or 14 AWG)

Connecting Multiple Mats

Multiple mats can be connected to

a single thermostat or relay. Refer

to Table 2 and Table 5 for details on

calculating the maximum number of

mats per control or relay.

TapeMat

connections

(Junction box

near mats)

To prevent the risk of personal injury and/or death, do not perform any electrical work unless

qualified to do so. Work should be done with great care and with power turned off to the

circuit being worked on. Follow all local building and electrical codes.

The thermostat is not fully illustrated in these diagrams in order to simplify them. These

diagrams are given only as examples of how to properly connect multiple mats. Care must

be taken not to overfill a box. Be sure to use wire nuts that are the correct size for the

connections being made. Follow all codes for wiring.

All electrical work must be done by a qualified licensed electrician in accordance with local

building and electrical codes, and the National Electrical Code (NEC), especially Article 424

of the NEC, ANSI/NFPA70 and Section 62 of CEC Part 1.