Install Instructions

15 of 36 © 2016 Watts Water Technologies
Install CableStrap
STEP 4.5
Measure the edge of the Heated Area where
CableStrap will be installed.
Double-sided tape
STEP 4.6
Cut the CableStrap to length using metal
shears.
STEP 4.7
Secure the strap to the floor. Depending on
the floor type, different methods may be used.
Concrete, self-level, or similar: Double-sided
tape (if included with your cable), hot glue, or
strong spray adhesive may be used if the floor
is well cleaned and the strap is wiped free of
any oils. However, it is highly recommended
to also place screws at each end of the strap,
and every 4 to 5 feet, to ensure it does not
come loose. If using a strong spray adhesive,
apply to both the back of the strap and the
floor where it will be placed, and carefully
follow all spray manufacturer’s instructions
and cautions.
Cut another piece of strap for the other end
of the area and secure to the floor.
Hot glue
Spray adhesive
OR
OR
OR
Plywood, cement board, or similar: Galvanized
nails or screws may be used to secure the
strap every 6" to 10".
Galvanized nails
Screws