specific installation instructions

SunStat / Relay Connections

Load 1

Line 1

Line 2

Black

White

Load 2

Connecting Multiple Cables

Multiple cables can be connected to

a single SunStat or SunStat Relay II.

Refer to Table 2 and Table 5 for details

on calculating the maximum number

of cables per control or relay.

Power

Lead From

WarmWire

Cable 1

WarmWire

Connections

(Junction Box

Near Cables)

SunStat or Relay

Power Supply (120

VAC or 240 VAC)

Power

Lead From

WarmWire

Cable 2

Standard NM

Cable (12 or

14 AWG)

To prevent the risk of personal injury and/or death, do not perform any electrical work

unless qualified to do so. Work should be done with great care and with power turned off

to the circuit being worked on. Follow all local building and electrical codes.

The SunStat is not fully illustrated in these diagrams in order to simplify them. These

diagrams are given only as examples of how to properly connect multiple cables. Care

must be taken not to overfill a box. Be sure to use wire nuts that are the correct size for

the connections being made. Follow all codes for wiring.

All electrical work must be done by a qualified licensed electrician in accordance with local

building and electrical codes, and the National Electrical Code (NEC), especially Article

424 of the NEC, ANSI/NFPA70 and Section 62 of CEC Part 1.