Brochure
Table Of Contents
C-ST-FullLine
18
ProMelt® Controls
• Compatible with ProMelt Cables & Mats
• Automatic and manual melting options
• Pole-mount, in-slab or surface-mount sensing
• Control options from 30 to 200 amps per unit
• 'All-in-one' control for smaller systems
• 24 VAC control with connection to ContactorPro
for larger systems
Safe, reliable control for ProMelt systems
Select the best control package for your installation.
• Total the amps of the mat and cable for each zone before comparing control options.
• Zones with less than 60 amps can use an all-in-one control solution (PM-2C or PM-5).
• The PM-L1 to L3 & PM-519 kits connect to a ContactorPro panel to control zones of any size.
Sensor at top
of control
ProMelt Snow Sensor Control PM-2C
The PM-2C operates on line voltage with a 30 amp capacity. This all-in-one control
includes a snow sensor on the top-facing side. Features include automatic or manual
operation, adjustable trigger temperature and an adjustable drying cycle.
Order# 81011699 Model# 300600
ProMelt Snow Sensor Control PM-5
The PM-5 operates on line voltage with a 60 amp capacity. This all-in-one control includes
a snow sensor on the top facing side. Features include automatic or manual operation,
adjustable trigger temperature and an adjustable drying cycle.
Order# 81014247 Model# 300580
System Size Operation Sensor Control Required Recommended
Up to 30 amp Automatic start/timed stop melting Pole-Mount PM-2C - PM-DP
Up to 60 amp Automatic start/timed stop melting Pole-Mount PM-5 - PM-DP
Any Size Automatic start & stop melting with slab temperature control Surface-Mount PM-L3 ContactorPro Panel -
Any Size Automatic start/timed stop melting Pole-Mount PM-L2 ContactorPro Panel -
Any Size Manual start & stop melting with slab temperature control In-Slab PM-L1 ContactorPro Panel -
Any Size Outdoor patio heating (no snow melting) In-Slab PM-519 ContactorPro Panel -