User Guide

 3of6 ©203WattsRadiant

Jewellerscrewdriver
Phillipsheadscrewdriver
•
•
WireStripper•
 -----------------------------------------------------

Choosetheplacementofthethermostatsearlyintheconstructionprocesstoenable
properwiringduringrough-in.
Considerthefollowing:
InteriorWall.
Keepdry.Avoidpotentialleakageontothecontrol.
RelativeHumiditylessthan90%.Non-condensingenvironment.
Noexposuretoextremetemperaturesbeyond32-22°F(0-50°C).
Nodraft,directsun,orothercauseforinaccuratetemperaturereadings.
Awayfromequipment,appliances,orothersourcesofelectricalinterference.
Easyaccessforwiring,viewing,andadjustingthedisplayscreen.
Approximately5feet(.5m)offthefinishedfloor.
Themaximumlengthofwireis500feet(50m).
Stripwireto3/8"(0mm)forallterminalconnections.
Usestandard4conductor,8AWGwire.
•
•
•
•
•
•
•
•
•
•
•
 ------------------------------------------------
 -------------------------------------------------
8AWGLVTSolidWire
(LowVoltageConnections)
•
Toremovethethermostatbase:
Locatethetabonthebottomofthethermostat.
Pushthetabwitheitheryourthumborwithascrewdriver.
Liftthethermostatfrontawayfromthethermostat’sbase.
•
•
•
