Submittal Sheet

For Residential and Commercial Snow Melt Applications
Job Name
––––––––––––––––––––––––––––––––––––––––––––
Contractor
––––––––––––––––––––––––––––––––––––––––––––
Job Location
––––––––––––––––––––––––––––––––––––––––––
Approval
––––––––––––––––––––––––––––––––––––––––––––––
Engineer
–––––––––––––––––––––––––––––––––––––––––––––
Contractor’s P.O. No.
–––––––––––––––––––––––––––––––––––
Approval
–––––––––––––––––––––––––––––––––––––––––––––
Representative
–––––––––––––––––––––––––––––––––––––––––
PM-DP Display Panel
CDP-2
Deice On
Snow Sensor
Control/Display Panel
Standby
Automatic
Manual On
SYSTEMS
AUTOMATED
ENGINEERING
PM-DP fits directly into a single gang box and can be fitted with a standard
"modular" electrical cover plate. A CS-1 pigtail is included with the PM-DP.
Terminal Block
LED Indicator
Switch
!
WARNING: General Safety Instructions
1. THIS UNIT SHOULD BE INSTALLED ONLY BY
QUALIFIED PERSONNEL!
2. Disconnect all power from the control before opening the
front cover plate.
√ Description Order #
PM-DP Remote Control 81012360
!
CAUTION
This Engineering Sheet is not intended to provide full installation
instructions and safety information. In order to avoid property
damage or injury, please refer to the complete installation manual
and product safety information provided with the product.
Remote control panel
The PM-DP provides direct remote operation for the PM-2B, PM-5,
PM-224, and PM-824 snow sensors. Users can monitor both the
operating mode and the activation state of the sensor. Additional
control features include setting automatic, manual, or standby operation.
Specifications
Features
The PM-DP offers the ability to monitor or operate the snow melting
system from a remote location.
The corresponding LED will blink, indicating operation, instead of
remaining constant.
Supply Voltage Derived from Snow Sensor
Compatible Sensors
PM-2B
PM-5
PM-224
PM-824
Operating Temperature Range -40°F (-40ºC) to 185°F (85ºC)
Modes
Automatic
Manual
Standby
Dry Cycle Time Based on Sensor Setting
Location Used Indoor
Wiring Type
22 AWG (minimum)
5 or 6 Conductor
Maximum Distance 800 ft. (243.8 m)
Function Feature
Standby Set snow sensor to ignore precipitation
Automatic
Automatically activates snow melt system
based on sensor settings for temperature,
precipitation, and run time
Manual
Will activate the snow melt system for the
"dry cycle" time determined by the sensor.
Will automatically return to Automatic
mode upon completion
Watts Radiant product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements, please
contact Watts Radiant Technical Service. Watts Radiant reserves the right to change or modify product design, construction, specifications, or materials without
prior notice and without incurring any obligation to make such changes and modifications on Watts Radiant products previously or subsequently sold.
ES-ST-PMDP