Install Instructions

Important Safety Information

This is a safety-alert symbol. The safety alert symbol is shown alone or used with

a signal word (DANGER, WARNING, or CAUTION), a pictorial and/or a safety

message to identify hazards.

When you see this symbol alone or with a signal word on your equipment or in

this Manual, be alert to the potential for death or serious personal injury.

This pictorial alerts you to electricity, electrocution, and shock hazards.

This symbol identifies hazards which, if not avoided, could result in death

or serious injury.

This symbol identifies hazards which, if not avoided, could result in minor

or moderate injury.

This symbol identifies practices, actions, or failure to act which could result

in property damage or damage to the equipment.

Table of Contents

Important Safety Information .....................3

Phase 1 - Preparations ..............................5

Phase 2 - Electrical Rough-in ..................10

Phase 3 - Cable Installation .....................12

Phase 4 - Finish Coverings ......................14

Phase 5 - Control Installation ..................16

Appendices .............................................. 17

Troubleshooting .......................................24

Warra nty ................................................... 27

Table 1

As with any electrical product, care should be taken to guard against the

potential risk of fire, electric shock, and injury to persons. The following

cautions must be observed:

Local building or electrical codes may require modifications to the information provided. You are

required to consult the local building and electrical codes prior to installation. If this information

is not consistent with local building or electrical codes, the local codes should be followed.

NEVER cut the heating cable. Doing so will cause dangerous overheating and will void the

warranty. The power lead may be cut shorter if necessary, but never removed from

the heating cable.

NEVER bang a trowel or other tool on the cable. Be careful not to nick, cut, or pinch the cable

causing it to be damaged.

NEVER overlap or cross over the heating cable on itself, or place heating cable closer than

4 inches from another heating cable or power lead cable. This will cause dangerous

overheating.

NEVER allow a power lead or sensor wire to cross a heating cable.