User's Manual

CrossFire – A revolution in RF Transport for In Building Wireless
User Manual
76 Revision 1.0.1
7. System Debugging Setup
After installation and connection, power the devices on. At this point, it is strongly recommended that a laptop be
connected to the Master AU to enable system debugging. Check each device’s working status. The optical interface
indicator LEDs should be green and stay lit and the STATUS indicator LEDs should be green and flashing slowly. Now, start
the online debugging according to Figure 7-1 and Figure 7-2.
Master AU
No
Yes
Connection & Query Status
Completion
Channel Gain Adjustment
Field Intensity Test &
Antenna Adjustment
Alarm Parameter Configuration
Connection & Query Status
NMS Setup
Alarm Parameter Configuration
Channel Property Steup
Channel Gain Adjustment
Field Intensity Test &
Antenna Adjustment
Completion
Figure 7-1 AU (left) and RU (right) Debugging Procedures