Operation Manual

11
2. Learning
For SRC-3200, we have built in an auto-guide system to help users in
operation of Learning function. (The auto-guide system only works for the
Soft keys setting, refer to the P4 for detailed illumination)
Notes:
 Before operation, please note that you are
required to keep 2-4 inches distance away
between SRC-3200 and the original remote and
put them in a line (as shown on right side).
 During learning, please also keep pressing each
learnt key of the original remote until the “OK ”
message appears on the screen of SRC-3200 and
hear a beep. For some special codes, you
might have to learn all keys twice as general
operation. As you see “ERROR” message
appears but hear TWO beeps during
learning, please press each learnt key of the
original remote once again until you see the
“OK” message and hear only ONE beep.
Otherwise, you will see the “ERROR”
message blinking once and hear THREE
beeps if the learning fails.
(1) Press “LEARN” in the setup mode to start
the learning function. The auto-guide
system is started up in the meantime,
that allows the IR codes of the original
remote control to be learnt by SRC-3200
one by one according to the blinking keys
on the screen.