Operation Manual

31
Problem Solution
An “ERROR”
message displayed
during operation
1. No code was saved in the pressed key or the
operation is wrong.
The SRC-3200 can’t
control desired
devices.
1. Check if the desired device on the SRC-3200 is
selected.
2. Move closer to the device. The maximum
operating distance is approximately 30 feet.
3. Make sure that you are aiming the SRC-3200
directly at the device and there is no obstruction
between the SRC-3200 and the device.
4. Make sure that the learning function or the
preprogrammed code is executed properly.
A key performs two
or more functions
1. Some remote controls issue the multiple
commands in a key when it is operated. Make
sure you learn IR codes into different keys to
separate respective functions.
Macro does not
work.
1. Make sure that you aim the SRC-3200 at the
device while the Macro commands are sent.
2. Macro is not set up properly. Repeat the macro
setup procedure.(Page 13 Macro)
The LCD screen
turns off.
1. The SRC-3200 is defaulted to switch the LCD off
automatically after the SRC-3200 is left unused
for 90 seconds.
2. Replace new batteries when the old ones are run
out the power.