Operation Manual

8
1.1 Auto Search
Before using this function, please turn on your device first, and then aim
the SRC-3200 at the signal receiver of your device. If the device shuts
down suddenly, it means you might have found the remote code of the
device.
(1) Press “AUTO” after you enter the setup page, and the SRC-3200 will
start outputting the codes stored in the database one by one. Press
any key to stop the output operation of the SRC-3200 when the
device is turned off.
EX. Set up TV
Turn on the TV Aim the SRC-3200 at
the TV
Press “AUTO” to stat
auto searching
0010
0011
0012
The pre-programmed
codes will start
outputting. When the
TV is turned off, press
any key to stop the
action