User Manual WSU43 Wireless solar rear view system SUNWAYI 100% DIY, intalls in minutes Wireless No Wire / All-in-One Low Power Consumption Solar Charging NO DRILLING / NO SPLICING User Manual Version 1.
INTRODUCTION TABLE OF CONTENT Welcome 01. CONPONENTS 1. All-in-one camera with built-in battery and solar panel Thanks for your choosing WSU43 product, which provides value and quality. Please read this User Manual carefully before using the product. Wireless SolarPower RearVision can display image behind the vehicle and can be used when backing up or any time you want to view behind the vehicle (even while your vehicle is in park). 2. 4.3 inch monitor 3.
02. GETTING STARTED Remove the whole Wireless SolarPower RearVision WSU43 packing or assembly and make sure all components are included. 03. INSTALLATION Camera Installation Hex/Nut(female)ø10xM6x5.8mm X4 1. Plate Washer ø13xM6x1mm X4 Charge the All-in-one camera’s built-in battery Hex Nut PM6x30mm 1. Connect the supplied USB cord to the micro USB port of the All-in-one camera. 2. Plug the USB cable into any standard USB charger with an output rating of 500mA or higher. 3. Charge 2 to 5 hours.
04. MONITOR MOUNT 05. OPERATION 1. Two way to mount the monitor 1) Stick on the dash board: Fix holder bracket A (see figur 1) to the install position of monitor via screw tool, choose and clean a right place on the dash board, tear the paper of the monitor holder’s sticky tape, put and press the holder on the dash board. 3. When the vehicle is shut off, power is removed from the monitor and the monitor will shut off automatically, and the camera will stop work.
06. BUTTON & SETTING 2. The Up button: Short Press to change/add parameter value at the menu setting interface. 06. BUTTON & SETTING Brightness/Contrast/Color settings are similiar. Take Brightness as an example,when brightness is chosen, press UP or DOWN button on the interface to adjust the brightness as shown bellow: 3. The Down button: Short Press to change/decrease parameter value at the menu setting interface.
09. SPECIFICATION 08. INFORMATION Battery Icon is on the top right corner of the screen, indicates the relative capacity of the built-in lithium battery of the All-in-one camera when a video image is present. CAMERA Signal strength of the received image is on the top left corner of the screen when a video image is present. Sleeping Current: <0.
10. DISCLAIMER WARRANTY INFO WSU43 Wireless SolarPower RearVision is intended to assist responsible driver, but it doesn’t relieve a driver from full responsibility for operation of the vehicle. It is the driver’s sole responsibility to avoid contact with any objects, animals, especially persons.
12. TROUBLESHOOTING 13. CARE & MAINTENANCE ♦ If the monitor doesn’t turn on when power is applied: Cleaning 1. Check to make sure the power source is active (if your cigarette lighter is Don’t clean or wipe the All-in-one Camera with solvents or chemical materials. If necessary, remove dirt or stains using a soft cloth dampened with a mild detergent solution. switched with vehicle ignition, your monitor will only work when the vehicle is running or the key in the ON position). 2.
14. FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
