Owner's Manual

Page 2 of 5
Transmitter:
Installing Batteries:
The remote transmitter uses two (2) “AAA” batteries. To install batteries:
1. Press down the battery door and remove the battery door.
2. Install uses two (2) “AAA” batteries batteries as indicated on transmitter.
3. Close the battery door by snapping in place.
4. The batteries should be replaced when the low battery indicator display in LCD.
5. When both batteries are installed, the transmitter will initialize for 1 seconds and then is
ready for use.
LEARNING TRANSMITTER TO RECEIVER
1. The transmitter privacy (DIP) switches are preset at the factory. Setting the 4 bits DIP
Switches on transmitter to select a security code.
2. Put the receiver slide switch to “REMOTE” location. Using a small screwdriver or end of a
paper clip gently press and Hold the LEARN button on the receiver to accept the transmitter
security code upon initial use,When you release the LEARN button the receiver will emit an
audible “beep
3. After the receiver emits the beep. press the transmitter “ON “or “OFF” button and release at
once. The receiver will emit several beeps indicating that the transmitter’s code has been
accepted into the receiver.
4. If you are unsuccessful in matching the security code on the first attempt repeat step 1-3
WARN
ING
Do not use two (2) or more remote control systems in the same area with the same dip switch
settings, as they will communicate with each other. This may cause the appliances to
malfunction.
Dip Switch (Default)
Transmitter