SDS

SAFETY DATA SHEET
Date Prepared : 05/10/2016
MSDS No :
Date-Revised : 09/14/2017
Revision No : 12
dioxide and phenolics.
FIRE FIGHTING PROCEDURES: Use water spray to keep fire-exposed containers cool and to knock down vapors which may
result from product decomposition.
FIRE FIGHTING EQUIPMENT: As in any fire, wear self-contained breathing apparatus pressure-demand, (MSHA/NIOSH
approved or equivalent) and full protective gear.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon Dioxide, Carbon Monoxide and other toxic or irritating compounds may
form when heated to decomposition.
6. ACCIDENTAL RELEASE MEASURES
GENERAL PROCEDURES: Contain spilled material if possible. Absorb with materials such as: Sand. Polypropylene fiber
products. Polyethylene fiber products. Remove residual with soap and hot water. Collect in suitable and properly labeled
containers. Residual can be removed with solvent. Solvents are not recommended for clean-up unless the recommended
exposure guidelines and safe handling practices for the specific solvent are followed. Consult appropriate solvent Safety Data
Sheet for handling information.
COMMENTS: This material is a water pollutant and should be prevented from contaminating soil or from entering sewage and
drainage systems and bodies of water.
7. HANDLING AND STORAGE
GENERAL PROCEDURES: Use with adequate ventilation. Avoid contact with eyes, skin and clothing.
HANDLING: Avoid breathing (dust, vapor, mist, gas). Avoid contact with skin, eyes and clothing. Keep container closed when not
in use.
STORAGE: Store in a cool place in original container and protect from sunlight. Keep away from sources of ignition.
STORAGE TEMPERATURE: Ambient room temperature (70F/21C).
LOADING TEMPERATURE: Not Determined
LOADING/UNLOADING VISCOSITY: Not Determined
STORAGE PRESSURE: Not Determined
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
ENGINEERING CONTROLS:
Use local exhaust ventilation, or other engineering controls to maintain airborne levels below exposure limit requirements or
guidelines. If there are no applicable exposure limit requirements or guidelines, general ventilation should be sufficient for most
operations. Local exhaust ventilation may be necessary for some operations.
PERSONAL PROTECTIVE EQUIPMENT
EYES AND FACE: For normal conditions, wear safety glasses. Where there is reasonable probability of liquid contact, wear
splash-proof goggles.
SKIN: Wear rubber gloves to avoid prolonged skin contact.
RESPIRATORY: Use only in a well ventilated area.
PROTECTIVE CLOTHING: Wear rubber gloves & apron.
WORK HYGIENIC PRACTICES: Avoid contact with skin and eyes. Wash thoroughly after handling.
9. PHYSICAL AND CHEMICAL PROPERTIES
Page 3 of 6
Epoxy Resin