SDS

Page 4/9
Safety Data Sheet
according to 1272/2008/EC (CLP) and OSHA GHS
Revision: June 18, 2015
Trade name: Super Lube® Air Tool Pneumatic Lubricant
(Contd. of page 3)
40.1.5
SECTION 7: Handling and storage
·
7.1 Precautions for safe handling
Store away from oxidising agents.
·
Information about fire - and explosion protection:
No special measures required.
·
7.2 Conditions for safe storage, including any incompatibilities
·
Storage:
·
Requirements to be met by storerooms and receptacles:
No special requirements.
·
Information about storage in one common storage facility:
Store away from foodstuffs.
Do not store together with oxidising and acidic materials.
·
Further information about storage conditions:
None.
·
7.3 Specific end use(s)
No further relevant information available.
SECTION 8: Exposure controls/personal protection
·
Additional information about design of technical facilities:
No further data; see item 7.
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of materials with critical values that have to be
monitored at the workplace.
·
DNELs
No further relevant information available.
·
PNECs
No further relevant information available.
·
Additional information:
The lists valid during the making were used as basis.
·
8.2 Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
Keep away from foodstuffs, beverages and feed.
Avoid contact with the eyes and skin.
·
Respiratory protection:
Not required under normal conditions of use.
·
Protection of hands:
Gloves not required under normal conditions of use.
Wear protective gloves to handle contents of damaged or leaking units.
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation.
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer. As the product is a preparation of several
substances, the resistance of the glove material can not be calculated in advance and has therefore to be
checked prior to the application.
·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to
be observed.
(Contd. on page 5)