Owner's manual

2-8
SUPER i2DMR-8G2/i2DMR-iG2 User's Manual
F. Installing the Heatsink on the CPU(*for CPU w/o Heatsink
only)
(*Warning: Do not apply any thermal grease to the heatsink-the required
amount of thermal grease has already been applied.)
1. Place the heatsink (P/N SKT-0046) on top of the CPU so that the four
mounting holes are aligned with those on the retention mechanism as
shown in Figure 1 below.
2. Screw in two diagonal screws (ie the #1 and #2 screws) until just
snug (do not fully tighten), then do the same with the remaining diagonal
screws as shown in Figure 2 and Figure 3.
1) Locate the four mounting holes on
the heatsink retention module.
Figure 1
Figure 2
Figure 3
(*Note: To maximizing the cooling effect of the i2DMR-8G2/iG2, we
strongly recommend that Supermicro's proprietary heatsinks (SNK-046)
be used with the Itanium 2 CPUs.)