User's Manual

How to use the “Code Learning” for RW6400
Please following step by step
1. Turn ignition (on) and turn hood (on) (waiting for 5 second for signal feed back)
2. Press the override switch 4 times (then the parking light will flashed 4 times, led steady light
on)
3. Presses the button ➀ (lock) and button ➁ (unlock) at same time, for new transmitter for
learning, siren chirps 2 times than waiting the LCD shows picture of “attain” it means this
transmitter is completed for code learning.
4. Presses the button ➀ (lock) and button ➁ (unlock) at same time, for 2
nd
new transmitter for
learning siren chirp 3 times than waiting LCD shows picture of “attain” it means this
transmitter is completed for code learning.
5. A main unit can at most accept for 4 transmitters code learning.
How to update program option function of RW6400
Please following step by step
1. Turn ignition (on) and turn hood (on) (waiting for 5 second for signal feed back)
2. Press the override switch 5 times (then the parking light will flash 5 times, led steady light on)
For example, program the option function #12 ”door luck pulse time” when finished above 2 steps,
then keep following the below steps:
★ Press override switch 12 times (means program the option function #12) each time press the
override switch, the Parking Light will flash once, for this #12 programming totally will be
flashed 12 times by 12 times pressing the override switch. When saw the 12
th
flash means the
system programming mode is on the #12 option function programming status.
★ after above, press the remote “lock” button, by the mean time, the parking light will flash
once for signal, that means the programming procedure for set-up the option function #12 is
finished. Please reference the ”update program option chart” the system was set-up the
central door lock/unlock as “3 seconds pulse”, that means every lock/unlock pulse is 3
seconds, this is for match the original setting for central door lock/unlock on the MERCEDES,
BENZ.