Installation Manual

CAUTION: EXTREME CAUTION SHOULD BE EXERCISED WHEN INTALLING FLAG POLES NEAR
OVERHEAD POWERLINES OR IN THE VICINITY OF BURRIED CABLES
Telescoping Flag Pole Installation Instructions
Congratulations on your purchase of our Telescopic Flag pole.
Ground
Level
Concrete
Sleeve
Stop-Bolt
Crushed Rock
Telescoping Flagpole
Sleeve that came with the Telescoping Flagpole
3 bags of pre-mixed concrete (40 lbs each)
Measureing stick
Level
Something to mix the concrete or cement
What You Will Need
Prepare a hole approximately 12” in diameter and 22” deep.
Place a bed of gravel or small rock in the hole.
Install the stop bolt and nut through the sleeve.
This is important since the bolt will keep the flagpole up off the bottom.
Place the sleeve in the hole with stop bolt facing down.
Place gravel or small rock in and around the sleeve to a height of 2”
from the bottom of the sleeve. This will help drainage.
Pour concrete or cement around the sleeve,
be careful not to get any inside of the sleeve.
Fill the hole approximately 1” from the ground level with the concrete.
Place the flag pole in the sleeve and level the flagpole from two sides.
When the sleeve is level, carefully remove the flagpole without moving the
position of the ground sleeve.
Let the concrete or cement set for at least 24hours.
Place pole in the sleeve and erect.
Please see additional instructions to use the pole.
Raising the pole- pull each section up slowly twist until it automatically
locks in position starting from the top inner section.
Lowering the pole – Hold on to the section to be lowered.
Press the locking button to release, twist, and allow the section to slide down slowly through the hands.
Insert the pole into the ground sleeve.
Install one long screw lock in the threaded hole of the ground sleeve collar
Tighten the screw lock against the pole to make a mark.
How to use your telescopic flagpole
1000 Westinghouse Drive Suite 1 New Stanton, Pa. 15672
877-734-2458
www.onlinestores.com
PLEASE NOTE:
If you have
purchased the Online Stores
Brand telescoping flagpole, you
will not have a locking collar
and stop bolt. These pieces are
not required for this flagpole.