User's Manual

SUPER TREND LIGHTING LTD.
Room304-306, 3/F., Hewlett Centre, 54 Hoi Yuen Road, Kwun Tong, Kln.,Hong Kong.
Tel: [phone] (6 Lines) Fax: [phone]
E-mail Address: [e-mail] Web Site: http://www.stll.com
DIN EN ISO 9002
ZN: 09 100 99401
R
n important
l A short circuit fuse is built into this lamp. This prevents serious accidents from
occurring if the lamp is used incorrectly.
l No internal parts are available form the lamp manufacturer for repair. If damaged,
do not attempt to disassemble or repair the lamp. Serious accidents may occur if
a repaired lamp is installed.
Federal Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 18 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not install and
used in accordance with the instructions, may cause harmful interference to radio
communications. However there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC ID: N8WLUXTEK
This device complies with Part 18 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received
Including interference that may cause undesired operation.