Assembly Instructions

Page 2 of 4 Revision Date: November 17, 2003
SuperDroid Robots, a Division of Team Half-Life Inc.
Copyright 2003
3. Mount the miniature servo to the scanner base as shown in Figure 3. Use #2-56
x 5/16” screw and secure with a washer, lock washer and nut. The mounting
holes for the servo are drilled out to accept the # 2 screws. Make sure the servo
is positioned as shown in the figure (the pivot arms are lined up).
Figure 3
4. Place the #2-56 1/2” screw in the pivot hole as shown in Figure 4. Use a washer
on each side and secure with a nut.
Figure 4
5. Place the pivot screw into the pivot hole in the base of the scanner. Apply slight
pressure without yielding the metal to allow the servo arm to go over the servo
mount. Let the servo arm snap onto the servo mount. You can manually rotate
the arm. Adjust the travel by moving it its stop then pull the arm off the servo and