Installation Instructions

5
 Measure the area to be installed: The board width of the last row shall not be less than 2” / 50 mm.
If so, adjust the width of the first row to be installed. In narrow hallways, it is recommended to install
the floor parallel to the length of the hall.
 UNDERLAY: If the floor does not have a pre-attached underlayment, an additional underlayment
is recommended in order to improve acoustic performance and absorb some irregularities on the
substrate. Best results can be expected with an underlayment of 0.04” / 1 mm to max 0.06” / 1.5
mm thickness with a high density (>397 lb / ft
3
/ >180 kg / m
3
) and high compressive strength
(>200 kPa) that supports the click system during daily use. Underlayments with a low density and
an inadequate compressive strength could damage the locking mechanism and will void warranty.
If the floor has a pre-attached underlayment, the use of an additional underlayment could damage
the locking mechanism and will void warranty.
 Underlayments over 1.5mm in thickness will void the warranty.