User Manual

17
ENFORCER Access Control Keypad with Proximity Card Reader
SECO-LARM U.S.A., Inc.
Programming User Codes and Proximity Cards (cont.):
Programming Visitor Codes for Output #1:
User IDs:
•
000
to
999
– 1,000 unique user IDs for user codes and prox cards for output #1.
•
001
to
100
– 100 unique user IDs for user codes and/or prox cards for output #2 or
output #3.
User Codes:
• A user code can be 4 to 8 digits long, and must have the same length as the master code if the
keypad is used in auto code entry mode (see pages 24~25).
• The master, super user, common user, and user codes cannot be the same.
Examples:
1. Program only a proximity card for user ID #017 for output #1:
10 1 017 READ CARD #
2. Program a user code for user ID #010 for output #1:
10 2 010 2275 #
3. Delete a proximity card for output #1:
10 5 READ CARD #
4. Delete code or proximity card stored in position #002 for output #1:
10 5 002 #
5. Delete all users for output #1:
10 0999
6. Program a proximity card for user ID #001 for output #1 for use with a common user code.
10 4 001 READ CARD #
7. Program a proximity card for user ID #023 for output #2 for use with a unique user code.
20 3 023 READ CARD 2468 #
Visitor codes are temporary codes that expire after use or after a specied amount of time has
elapsed. While active, they operate output #1 as normal user codes.
NOTE:
• Visitor codes cannot be used to deactivate the duress output (see “Operating Duress Codes” on
page 20).
• If a visitor code is programmed using a number previously programmed as a user code, the
visitor code will be kept and the user code will be replaced.