User Manual

ENFORCER Access Control Keypad with Proximity Card Reader

SECO-LARM U.S.A., Inc.

Quick Programming Guide:

This page is for installers looking to do a basic installation and programming of the keypad.

For more in-depth installation and programming instructions, see the Table of Contents on page 4.

Programming Tips:

• The master code, super user code, common user codes, and user codes cannot

be the same.

• A ashing center green LED indicates the keypad is in standby mode. A solid center green LED

indicates the keypad is in programming mode.

• If the keypad is set for Auto Code Entry Mode, your user codes will need to be the same

number of digits as the master code (see page 24).

Programming Instructions:

Follow the instructions below if the following covers your needs:

• A new master code.

• A single 4-digit user code for all users, and no proximity cards.

• One output to unlock a door.

• A 3-second delay time in opening the door after the output is activated.

1. Turn off the beeping before the 1-minute power-up period ends:

12 #

2. Change the master code:

0000 ** 01 xxxx #

NOTE:

0000

is the default master code,

xxxx

is the new master code.

3. Set the user code to operate output #1 (unlock the door):

10 2 000 xxxx #

NOTE:

000

chooses user ID #1 of 1,000 possible users (000~999).

XXXX

is the new user code for user ID #1.

4. Set the output #1 delay time (skip this step if the default value of 5 seconds is

acceptable):

51 3 #

NOTE:

sets the output #1 delay time for 3 seconds.

5. Exit programming mode: