User Manual

31
ENFORCER Access Control Keypad with Proximity Card Reader
SECO-LARM U.S.A., Inc.
User’s Guide to Operating the SK-1131-SPQ:
See “Programming the Master Code” and “Programming the Super User Code” on pages 13~15 for
functions specic to those authorized to use those codes.
Opening the Door:
In these examples, assume that the user code is
2275
, the common user code is
3526
, and a unique user code is
2468
.
• Security Level 1 – Card only
READ CARD
1 Long beep indicates that the door can be opened.
• Security Level 2 – Code only
2275 #
*
1 Long beep indicates that the door can be opened.
• Security Level 3 – Card + Common user code
READ CARD
2 Short beeps and a rapidly ashing center green LED indicates the card is accepted and the
keypad is waiting for the Common user code.
3526 #
*
1 Long beep indicates that the door can be opened.
• Security Level 4 – Card + Unique user code
READ CARD
2 Short beeps and a rapidly ashing center green LED indicates the card is accepted and the
keypad is waiting for the Unique user code.
2468 #
*
1 Long beep indicates that the door can be opened.
NOTE: For more information on security levels, please see “Getting Ready to Program” on page 10.
Operating the Egress Button:
Press the egress button from inside the protected premises to unlock the door and exit without
using the keypad.
NOTE: For more information on programming the Egress button, please see “Programming the
Egress Delay/Warning/Alarm” on pages 28~29.
* The
#
key is not needed if the keypad is programmed for auto entry mode. See pages 24~25.