User Manual

27⁄8” (73mm)
1½”
(38mm)
45⁄8”
(117mm)
6
ENFORCER Access Control Keypad with Proximity Card Reader
SECO-LARM U.S.A., Inc.
Overview:
LED Indicators and Keypad Sounds:
Parts List:
1x Keypad
1x Back box
2x Installation screws
2x Mounting screws
1x Diode
1x Manual
Keypad Sounds and LEDs
Status Sounds
(1)
Green/Red/Amber LED (Center)
In programming mode
– Steady ON
Successful key entry
1 Beep 1 Flash
Successful code/card entry
2 Beeps 2 Flashes
Unsuccessful code/card entry
5 Beeps –
Power up delay
Continuous beeping Continuous ashing
Output relay activation
(2)
1-Sec long beep –
In standby mode
(3)
– 1 Flash/sec
System refresh mode
2 Beeps Fast ashing for 2.5 min
Card/code already stored
1 Long beep –
Real time clock stopped after
power loss
Continuous 3 fast beeps
every 5 seconds
–
NOTE:
1. Keypad sounds can be programmed ON or OFF (see page 25).
2. Output relay activation sounds can be programmed ON or OFF (see page 25).
3. Green center LED ashing during standby mode can be programmed ON or OFF
(see page 26).
LED Indicators
Red LED (Left) Green/Red/Amber LED (Center) Green LED (Right)
Steady
Available for free connection
Programming mode (green)
Output #1 disabled (red)
Available for free connection
Flashing
–
Standby mode (green)
Inhibit mode paused (red/amber)
Keypad Locked (red/amber)
–