User Manual

ENFORCER 100LB/100CB Owner's Manual ENFORCER 100LB/100CB Owner's Manual
SECO-LARM U.S.A., Inc.
Page 6
the ignition is ON.
 If the shock sensor detects light taps on the
car, it will trigger the pre-intrusion alert (the
siren chirps five times and the parking
lights flash five times) to warn potential
thieves and vandals. However, if it detects
a strong shock to the car, such as shock
caused by prying the trunk open, it will
trigger the alarm for 30 seconds. (See
DUAL-STAGE SHOCK SENSOR, page 7)
 Optional SECO-LARM shock, motion,
glass-break, and microwave sensors will
offer your alarm additional protection.
Ask your SECO-LARM dealer.
While your alarm is armed, your car is
protected in the following ways:
 Potential thieves or vandals will be warned
by the flashing LED.
 If a thief opens a door, the alarm
immediately sounds the siren and flashes
the parking lights for 30 seconds. If the
opened door is not closed and current
sensing has not been selected, the siren
and lights will trigger up to four 30-second
cycles, after which the alarm will rearm.
 Turning the ignition key ON will trigger the
alarm for 30 seconds.
 The starter disable prevents the car from
being started.
 ANTI-CARJACK (optional) is triggered if
someone opens and closes a door while
TOTAL PROTECTION
To disarm the alarm, press the II button. The
siren chirps twice, the parking lights flash
twice, and the LED turns OFF. What happens
next depends on how your alarm is set (ask
your dealer):
 Alarm set for active arming with Secure
Lock
TM
OFF
The alarm is now completely disarmed.
 Alarm set for active arming with Secure
Lock
TM
ON
The system will automatically rearm and
relock the doors 30 seconds later unless a
door is opened during this time. This
prevents accidental disarming. During this
30-second period, the LED flashes quickly.
 Alarm set for passive arming
The system will automatically rearm itself
30 seconds later. If a door is opened, the
system temporarily disarms. Closing the
open door will again cause the system to
enter the 30-second rearm period.
NOTE — If set for Secure Lock
TM
, the doors
will lock when the system rearms. Otherwise,
the doors do not automatically relock.
DISARMING
If you lose your transmitter, you can disarm
your alarm with the ignition key and the
“VEL” switch. While your alarm is either
armed or triggered, turn the ignition switch
ON. Within 15 seconds, press and release
the VEL switch three times. The siren and the
flashing lights stop if the alarm was triggered,
and then chirp and flash two times. (Ask
your dealer where the VEL button is hidden.)
EMERGENCY DISARM
NOTE — If you use emergency disarm, just turn
the ignition OFF and close the doors when you
leave your car, and the alarm arms automatically.
Next time you open a door, you will have 10
seconds of quiet to turn the ignition switch ON
and press the VEL button three times to disarm
the alarm. This feature is cancelled next time
you use your transmitter to arm or disarm your
alarm.
Page 7
VALET
Sometimes you may not wish your alarm to
arm when you leave your vehicle. (For
instance, if you leave your car with a valet
attendant, you may not want to teach him how
the alarm operates.) If your alarm is set for
active (manual) arming, this is easy — don’t
press the
I button, and the alarm will not arm.
However, if your alarm is set to arm passively,
use the valet mode to prevent it from arming.
To enter valet, first disarm the alarm and turn
the ignition ON. Within 15 seconds, press
and release the VEL switch three times. The
alarm is now in the valet mode. The siren
chirps and the parking lights flash once to
confirm.
To exit valet, just turn the ignition ON and,
within 15 seconds, press and release the VEL
switch three times. The siren chirps twice and
the parking lights flash twice to confirm that
valet is exited and the alarm is now disarmed.
If you press the
I or II while the alarm is in
valet, the doors will lock or unlock, and the
parking lights will flash four times. The
alarm's emergency call for help and 2nd
channel output operate normally.
Any time your alarm is triggered (the siren is
sounding and the parking lights are flashing),
press the
I button of the remote once to shut
the siren and flashing parking lights OFF while
the alarm stays completely armed.
PATENTED STAY-SAFE DISARM
DUAL-STAGE SHOCK SENSOR
will trigger. (Your dealer can make the shock
sensor more or less sensitive to attack,
depending on your vehicle.)
NOTE — The shock sensor (and other add-on
sensors, and current sensing) will not trigger
the alarm until 4 seconds after the alarm is
armed.
Your alarm includes a patented dual-stage
shock sensor.
The first stage (pre-intrusion alert) warns
thieves the alarm is armed. For instance, the
alarm will chirp three times and the parking
lights will flash three times if the sensor detects
a light bump to the vehicle. However, if a thief
attacks the car with sufficient force, the alarm