Use and Care Manual

A
B
C
D
E
Package B
Package B
Package C
B
E
1. Use (2) 9/16”x 1-3/8”bolts (Package B) provided to connect the long stand (A) and the 2 square
poles (B) together.
2. Connect the assembly above (step 1) with the short stand (C) by using (2) 9/16”x 1-3/8”bolts
(Package B).
3. Add a cap nut and washer (Package C) to one end of the axle (D). Insert axle (D) through one
wheel (E) and into short stand axle hole (C). Place the second wheel (E) on the opposite end of
axle (D). Next place cap nut and washer (Package C) onto the exposed end of the axle (D).
Tighten cap nut with wrench provided (P). Check cap nut tightness periodically during routine
maintenance.
4. Install the handrail (G) onto the right hand side of the storage unit (F) and the working platform
(H) on the left hand side with the nuts, bolts and washers included (Package A).
ASSEMBLY PROCEDURE
H
F
G
5. Turn the storage cabinet (F) up side
down for convenient assembly. Insert
both ends of the short and long
stands onto the bottom of cabinet
(wheels opposite of the handle
attachment) and attach with bolts
(Package B). Use wrench provide to
throughly tighten bolts.Turn the
completed unit back to up-right
position.
Note: This task should be performed on
carpet or a section of cardboard to
avoid scraping the cabinet or
damaging your floor. This is a two
person task.
6. Place the main popper unit (I) onto the
topside of the storage cabinet (F).
Align the power cord located on the
right side of the popper unit with the
u-shape cut out on the right side of
the cabinet. Use the four spring
loaded latches to secure the popping
unit to the storage cabinet.
Caution: Do not attempt to move your
popper without securing the latches.
The popping unit will topple off
causing property and/or personal
damage.
Pot Heater
Stirrer
Warmer
Page 6 Page 5
F
F
NOTE: Cart base shown
removed for clarity.