UC-505DR USB/SD/MP3/CD/Radio Micro System INSTRUCTION MANUAL
WARNING TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
SAFETY INSTRUCTIONS 1. READ INSTRUCTIONS - All the safety and operating instructions should be read before the appliance is operated. 2. RETAIN INSTRUCTIONS - The safety and operating instruction should be retained for future reference. 3. HEED WARNINGS - All warnings on the appliance and in the operating instructions should be adhered to. 4. FOLLOW INSTRUCTIONS - All operating instructions should be followed. 5.
LOCATION OF CONTROL 1. FM STEREO INDICATOR 2. REMOTE SENSOR 3. FUNCTION SELECTOR 4. STOP 5. TUNING CONTROL 6. SKIP 7. VOLUME DOWN 8. POWER 9. TIME SET 10. HOUR 11. OPEN / CLOSE 12. LCD DISPLAY 13. BAND SELECTOR 14. PLAY / PAUSE 15. USB SLOT 16. SD CARD SLOT 17. SKIP + 18. VOLUME UP 19. MODE 20. ALBUM 21. MINUTE 22. FM ANTENNA 23. BATTERY BACKUP 24. SPEAKER JACKS (L/R) 25.
REMOTE CONTROL 1. 2. 3. 4. 5. 6. 7. 8. MODE VOLUME UP VOLUME DOWN SKIP PLAY / PAUSE SKIP + STOP ALBUM 1 2 3 4 6 5 7 8 BATTERY INSTALLATION Insert 2 x “AAA” size batteries into the battery compartment. Be sure that the batteries are inserted correctly to avoid damage to the remote control. Always remove the batteries when the remote control will not be used for a long period of time, as this will cause leakage to the batteries and subsequently damage to your set. Notes: - Use batteries of the same type.
RADIO OPERATION GENERAL OPERATION 1. 2. 3. 4. Set the “FUNCTION” selector to “RADIO” mode. Select desired band by using the “BAND” selector. Adjust radio frequency to your desired station by using the “TUNING” control. Adjust the “VOLUME” control to the desired level. FM / FM-STEREO RECEPTION - Set the “BAND” selector to FM mode for MONO reception. - Set the “BAND” selector to FM ST. mode for FM STEREO reception. The Stereo indicator light up to show FM ST. mode.
CD / MP3 OPERATION GENERAL OPERATION PLAY / PAUSE / USB Press to start playing CD / MP3 disc. Press again to stop playing CD / MP3 operation temporarily. Press again to resume playback. SKIP + SKIP - Press to go to the next track or back to the previous track. Press and hold while playing until you find the point of the sound. & STOP Press to stop all CD / MP3 operation. PLAYBACK 1. 2. 3. 4. Set the “FUNCTION” selector to “CD / MP3 / USB” mode.
CD / MP3 OPERATION PROGRAM Be sure to press the “STOP” button before use. 1. Press the “MODE” button, the display will show “P01” and flash. 2. Select desired track by using the “SKIP +” or “SKIP -” button. ( You may select a desired album by pressing “ALBUM” button. ) 3. Press the “MODE” button again to confirm desired track into the program memory. 4. Repeat step 2 and 3 to enter additional tracks into the program memory. 5.
USB / SD OPERATION GENERAL OPERATION PLAY / PAUSE / USB Press to start playing tracks from the USB / SD card. Press again to stop playing USB / SD operation temporarily. Press again to resume playback. SKIP + SKIP - Press to go to the next track or back to the previous track. Press and hold while playing until you find the point of the sound. & STOP Press to stop all USB / SD operation. PLAYBACK 1. 2. 3. 4. 5. Plug or slot in USB / SD card device to the port.