Installation Manual

21
Leg Installation/Adjustments/Alignment
Tecnogas ranges must be used only with the legs properly installed.
Remember that is indicated to set the high
corner of range so that the top of side
trim is 3/8” (0.95 cm) above countertop.
(see paragraph “Dimension”)
insert the legs in the appropriate
receptacles
Six height adjustable legs are delivered with the range in the polysterene container
situated over the appliance.
Before installing the legs, position the appliance near its nal location as the legs are
not suitable for moving the appliance over long distances.
After unpacking the range, raise it enough to insert the legs in the appropriate re-
ceptacles situated on the lower part of the appliance. Lower the range gently to
keep any undue strain from legs and mounting hardware. If possible use a pallet or lift
jack instead of tilting the unit.
Adjust leg height to the desired level by twisting the inside portion of the leg assem-
bly until the proper height is reached. Check with a level that the worktop alligne-
ment is perfectly level.