Installation Use and Care

22
|
REMOVE
To perform the following operation is necessary
to have eavy access to the back the range. While
performing this plese note that the range must not
be connected to the power and or gas lines.
1 - Remove the main back cover unscrewing the
two screws.
2 - Remove the gas regulator back cover unscrewing
the single screw.
3 - Fit the elbow on the regulator. Put the gasket,
in it.
4 - Connect the regulator to the manifold and re-
install the main back cover.
5 - Re-install the gas regulator backcover and x it
with two screws.
Gas Requirements